Titanium carbonitride films on cemented carbide cutting tool prepared by pulsed high energy density plasma

Hard films prepared by pulsed high energy density plasma (PHEDP) are characterized by high film/substrate adhesive strength, and high wear resistance. Titanium carbonitride (TiCN) films were deposited onto YG11C (ISO G20) cemented carbide cutting tool substrates by PHEDP at room temperature. XRD, XPS, SEM, AES, etc. were adopted to analyze the phases (elements) composition, microstructure and the interface of the films, respectively. The results show that, the uniform dense films are composed of grains ranging from 70 to 90 nm. According to the AES result, there is a broad transition layer between the film and the substrate, due to the ion implantation effect of the PHEDP. The transition layer is favorable for the film/substrate adhesion.     

三维内肋管内插入螺旋扭带的强化传热实验

本文分别以水和乙二醇为工质，在Ｒｅ数范围为：６００～４００００，Ｐｒ数范围为：５．５～１１０之间，对四根分别插入三种不同扭率螺旋扭带的三维内助管内的换热和流阻特性进行了实验研究。结果表明：三维内肋管内加装扭带的强化传热技术适用于低Ｒｅ数下高Ｐｒ数工质的管内对流换热强化。根据实验值得到了流阻和换热关联式。     

LD泵浦Nd：BGO晶体的自调Q激光器

首次实现了ＬＫ泵浦Ｎｄ∶ＢＧＯ固体激光器的１．０６４μｍ的激光输出，泵浦阈值功率为２５ｍＷ，在连续运转状态下得到最大为４０ｍＷ的ＴＥＭ００模输出，光－光效率为１３．３％，根据法拉第磁光效庆理论，了ＬＤ泵浦Ｎｄ∶ＢＧＯ自调Ｑ激光器的各种参数，并研制成该激光器，在该器件中，作为损耗调制元件的磁光调制器就是绕有线圈的Ｎｄ∶ＢＧＯ晶体本身，实验在重复率为１ＫＨｚ的条件下得到了ＦＷＨＭ为１００ｎｓ的稳定脉冲     

灰色Verhulst模型的样条插值函数的残差修正

本用样条函数对灰色Verhulst模型的残差序列进行插值拟合，然后作用于二阶线性微分方程，并以此修正原模型，得到一种新的预测模型的数值解，提高了拟合的精确度。     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

Triterpenoid Constituents of Huperzia miyoshiana

Thirteen triterpenoids, including three new ones, miyoshianois A (1), B (2) and C (3), were isolated from Huperzia miyoshiana. The structures of these new compounds were established as 3-O-dihydroferuloyltohogenol (1), 16-oxo-3β,21β-dihydrox-y-serrat-14-en-24-ferulate (2) and 16-oxo-3a, 21β-dihydroxy-serrat-14-en-24-ferulate (3), respectively, on the basis of their spectroscopic analysis.     

Synthesis,X-Ray Structure and Characterization of a Triruthenium Cluster Complex Ru_3~Ⅲ(μ_3-O)(μ-CH_3COO)_6(py)_2Cl with Four Steps One-electron Redox Processes

Great attention is currently paid to the synthesis of polynuclear transition metal complexes as well as their photochemical, photophysical, and electrochemical properties. The design of multicomponent systems capable of performing useful light- and/or redox-induced function is of special interest1. The oxo-centered carboxylate-bridge trinuclear ruthenium clusters have been investigated extensively during recent decades because they have remarkable electron-transfer properties, intense visibl…     

Time-Resolved Femtosecond Degenerate Four-Wave Mixing in LiNbO3：Fe,Mg Crystal

Forward degenerate four-wave mixing （DFWM） processes are investigated with a femtosecond pulsed laser in lithium niobate crystal doubly-doped with magnesium and iron （LiNbO3：Fe, Mg）. The pulse energy dependence reveals a pure third-order nonlinear response, and the third-order nonlinear susceptibility x^（3） in the material is evaluated to be 4.96 × 10^-13 esu. The time-resolved DFWM process shows a response time of x^（3） shorter than 100fs, which is due to the nonresonant electronic nonlinearities. Our results indicate that LiNbO3 crystals have potentials for ultrafast real-time optical processing systems, which require a large and fast x^（3） optical nonlinearity.     

Endpoint estimates for certain commutators of fractional and singular integrals

In this paper, the authors obtain the endpoint estimates for a class of non-standard commutators with higher order remainders and their variants. Moreover, the authors show that these operators are actually not bounded in certain cases.